Type 8010 - Inline Paddle Wheel Flow Switch
Type Description
The INLINE flow sensor/switch Type 8010 is specially designed for use in pure and water resembling fluids, free from air bubbles and magnetizable particles, to monitor minimum/ maximum values of flow. The sensor/switch is made up of a fitting (Type S010) and an electronic module (Type SE10), quickly and easily connected together by a Quarter-Turn. This device indicates the presence of a flow in the pipe by switching the Reed contact contained in the electronic module. The switching points Min./Max. for rising and falling velocities can be set with a screw within a defined range. The SE10 electronic module is available in two version: -Normally open (NO): The flow switches on the contact. - Normally closed (NC): The flow switches off the contact. These S010 fittings are available in two versions: - with a short blade «Range1» fitted for the fittings DN15 to 40. - with a long blade „Range2“ fitted for the fittings DN32 to 50.
Economic integration in pipe systems without any additional piping
Magnetic measuring principle
Mechanical adjustment of setpoint
Công tắc lưu lượng Type 8010 Burkert Vietnam
- Ashcroft
- AT2E
- MARK 10
- BIHL WIEDEMANN
- SPOHN BURKHARDT
- Schenck Process
- Baumuller
- CS Instruments
- COMET SYSTEM
- KELLER-ITS
- Guenther
- GEMU
- KOGANEI
- MATSUSHIMA
- NIRECO
- OHKURA
- Redlion
- SHINHO SYSTEM
- TDK LAMBDA
- Teclock
- SITEC
- TERACOM
- Tektrol
- Medenus
- EPI Flowmeter
- Okazaki
- Ulticell
- Netter Vibration
- MINIMAX
- KRACHT
- HELUKABEL
- THIẾT BỊ KHÁC
-
Trực tuyến:1
-
Hôm nay:425
-
Tuần này:1257
-
Tháng trước:5930
-
Tất cả:1459359